Shut off water supply valves then drain lines by turning faucet on. Use an Allen wrench to loosen the set screw holding the handle in place and remove handle. Loosen and remove the adjusting ring by using the special wrench provided in the repair kit. To remove cap, use pliers and turn counterclockwise. Protect cap finish with cloth. Remove spout assembly. Remove cam assembly by pulling up on ball shaft. You may need to use pliers. Removing seats and springs is best done by inserting a pencil or sharp tool into the seat assembly and gently lifting it out. Check and clean inlet ports before replacing seats and springs. To replace "O" rings on body, use a sharp tool to pry away from body. Roll new correct size "O" ring into place. When reassembling, be sure to align slot in ball with pin in body and key on cam with slot in body. Hand-tighten the cap, then screw adjusting ring into place with special wrench and replace handle. Turn on water and check for leaks. If necessary, further tighten adjusting ring.
|
|
|
